Messes are inevitable whether
it is caused by pets, children, or adults tracking in mud or spilling food. The
beautiful area rugs in your home are the main targets for such messes. Some
stains will be more difficult to deal with than others, but the sooner you
tackle them with proper rug cleaning Frisco methods, the better chances are of
removing them.
How long is the process for rug cleaning?
When cleaning messes, it can
take about 15 minutes to an hour, depending on the degree. Usually, you let the
stain remover soak in and wait for the rug to dry. The drying process can take
a few hours to a full day to complete. Adding a cool blow dryer or a fan can
help speed up the process.
If you decide to wash your
rug at home, deep cleaning may consume the better part of your day. However,
active cleaning time typically takes more than two hours. Depending on the
climate and the thickness of the rug, drying can take a few days. With some
smaller flatweave rugs, the process is much easier, but you may also need to
air dry them.
Spot cleaning messes
If you are unsure about your
rug cleaning Frisco technique, you can test first an inconspicuous part of your area
rug to make sure the colors do not run or the soap does not stain the material.
Remove any solids such as vomit, food, etc., and then blot the stain with a
clean towel to take out as much liquid as possible.
Apply a laundry detergent
diluted in warm water or a mild solution of dish soap. Soak the stain with just
enough of the stain. Avoid overwetting the area because it can spread the stain
and take longer to dry, encouraging mildew or mold. Rinse with warm water and
continue blotting the stain until there is nothing left. Do not scrub-blot
while applying pressures as it can damage the fibers.
Deep-cleaning small to medium area rugs
Small flatweave natural or
synthetic fiber rugs need vacuuming. If your area rug can fit in the washer,
check the care label and toss it in there. It is advisable to use a cold and
gentle wash cycle. After rug cleaning Frisco and washing, air-dry it. To prevent color
bleeding on wool and cotton rugs, use a fan to speed up the drying process.
For medium flatweave,
low-pile, and high-pile synthetic area rugs, remove as much dust as possible
before wetting the material. Vacuum both sides to take care of dust thoroughly.
Preferably, take your rug outside and beat it over your balcony or deck.
Use mild dish soap and test
a small area of your rug to find out if the colors bleed or the cleaner leaves
a mark. Treat the stains and spots accordingly. If your test area looks fine,
you can proceed with the task using a soft bristle brush to scrub the cleaner
into the surface of the rug. If the colors run, consider taking your area rug
to a professional cleaner.
